Common tech issues and maintenance tips
BMX is very much a ‘DIY’ activity. In this post I will try to shine a bit of light on some of the tech issues or maintenance problems we experience as riders. Let’s count ’em down…
Issue: The ‘clicking’ of your cassette hub is quieter, it makes a low mushy grinding noise or feels like you have ‘grit in your teeth’.
Cause: Packing the cassette hub driver-compartment with too much grease is never a good idea. To lightly lubricate is preferable. Too much grease clogs the pawls and springs (also attracts dirt) causing them to stick to the driver body and not engage fully. This makes it dangerous to pedal.
Remedy: You paid good money for your cassette hub, so look after it! Your cassette is the most intricate part on your bike, that’s why it only makes good sense to take proper care of it. Extract the driver, clean it throughly and add a very light grease/lubricant to the seal and some to the internals. In essence, the mechanism in itself does not need to be lubricated.
Feel it in your feet.
Issue: Sore feet after or during a session. Bruised ankles and sometimes (as in my case,) broken toes.
Cause: Your shoes may need replacing. Everyone has a preferred shoe type that they like to look fly in, but the sole is just as, if not more important than a good quality upper. Riding with soft or worn soles is like looking for some kind of injury.
Remedy: Noticed how much you use your feet? Take care of them, insert them into quality footwear that will protect them as well as keep you comfortable.
Pssssst!! No inflation, only deflation!
Issue: No matter what you do, your tube keeps going flat or you keep getting punctures.
Cause: You are not using a rim strip or your tyre is old, worn and/or thin. Could also be that you are using a low-quality tube…
Remedy: The obvious thing is to patch the tube or replace it. Finding the root of the problem could save you a couple o’ gray hairs and a few missed sessions. Check that your rim strip is covering all the sharp bits on the inside of your rim. Feel around the inside of the rim where the tyre bead sits. Use a cloth or ball of paper to rub out the inside of the tyre. You may have something sharp stuck the tire that only pokes through once you are a few blocks down the road…
Bonus tip. It never hurts to be safe. Buy a roll of electrical insulation tape, cover the entire inside of the rim with 1 or 2 layers, then add your rim strip.
Laziness… it’ll cost ya.
Issue: Rusty bike, rusty or greasy chain…
Cause: You probably wash your bike (or not at all!) with soap and water.
Remedy: Take better care of your bike. Clean it with a damp/wet rag if it’s really dirty – but rather don’t let it get to that point. A dry, clean rag and a tooth brush works for everyday gunk. Use a bike cleaner such as XtremeGreen-that shit works wonders! A wire brush and some elbow grease on the chain will have it looking fresh again in no time.
Bonus tip: Never use cooking oil or Vaseline on your chain. I’ve never seen a good result with these substances and all you end up with is gritty gunk, believe it!
“Pop-corn in my BB”. A popping or grinding sound from the Bottom Bracket.
Issue: You just bought new BB bearings, now a few weeks later they are creaking/making popping noises.
Cause: It’s likely that you used a steel hammer or something metal to fit the bearings into your frame (or get them out). Never, ever use a steel instrument on bearings! The harsh impact of steel on steel causes the ball bearings to crack and shatter.
Remedy: A wooden or plastic mallet is the best solution. If you don’t have either, a block of wood against the bearing works just as well.
“It’s that grinding teeth sound”… The creaking Headset.
Issue: Your headset pops, makes a dry noise or creaks under pressure.
Cause: Your frame facings and/or bearing cups may be dirty. You may even have a cracked bearing, worn headset parts or missing headset pieces.
Remedy: Your frame facings or bearing cups need to be cleaned and re-greased. Check your bearings for cracks. You may have too many headset spacers. In the worst case scenario, your fork steerer may be bent or your frame’s head-tube may have become ovalised. More on headset installation…. here.
Chain drag… its a terrible thing.
Issue: You bought a brand new chain, fitted it and now it makes a terrible noise when you pedal.
Cause: Your sprocket or cassette teeth are worn (shark-fin shaped), or you may have fitted the chain upside down.
Remedy: Not much you can do here other than replace the sprocket/cassette driver. You can ‘pedal it in’ till the sprocket stops making the noise, but it is risky business as you run the risk of ruining your new chain. I have heard of some filing the tips of the sprocket/cassette driver teeth so that they don’t catch on the chain anymore, but I wouldn’t get into all that…
Issue: Your brake cable frays after it has been cut.
Cause: Incorrect tools have been used or your side cutters/cable cutter is blunt.
Remedy: Purchase a decent cutting tool or simply visit your local bike shop and get them to fit it for you. Don’t forget to add one of those cable nipples to the end of your cable, a spoke nipple works just as well. Crimp that old nipple to the cable with a side cutters.
Hey Gramps! Lower back pain?
Issue: It happens to the best of us, some have spent money on expensive doctors to trying to figure out what the cause is. Some have even given up BMX all together because the pain is unbearable.
Cause: In my experience it’s usually the bike setup that plays a major role. For some it could just be growing pains that you will eventually grow out of but it IS also possible that your frame is too short or, in most cases, that your bars are too small.
Remedy: Experiment with your bike setup. There is no set formula but you may find small changes here and there can help. In cases of unexplained lower back pain I would suggest testing a bigger pair of handle bars for a couple of sessions. I cannot recall a time that this has not either helped or actually sorted the problem out altogether. It’s hard to believe that such a minor thing could have an impact to something so serious. Ask Ruben Alcantara, he knows all to well about back pain. Obviously if its not going away; consult your local Sangoma for advice.
Megatron what what?
Issue: You hear ‘boof boof boof eeeeiaaa-a-a-a bwaahhwwaawaa” coming from your ear phones…
Cause: Someone probably sabotaged your Ipod with music left behind by those Transformer things. Little do you know…… it’s killing you… s l o w l y….. ——————————–
Remedy: Replacing your earphones may eliminate the danger, but it most likely has more to do with your choice of music.
Press delete next time you find yourself wanting to sync with anything marked ‘dubstep’.
Have any questions, insight or something to add? Holla in the comments below.